When motion is detected, I'm sent 5 snapshots, on MeShare. There is only a couple of seconds between shots. How do I increase the time between shots or increase the number of shots per motion detection?
For example, when a can pulls into my driveway, I get 5 shots of the car driving up, but none of the people that get out of the car. The sensitivity is set so only to detect people at the back door, but still picks up the car first, that's about 20 feet out of the sensitivity area. If there was more time between shots or more shots, I would be able to tell who was getting out of the car and coming to my back door.
Can you change the delay time between motion detection shots, so that you get 5 shots of the car driving up, then 30 seconds later take 5 more shots if there is still motion detected? There seems to be a very long delay between the first 5 shots and the next time the DVR sends out another 5 shots, even if motion is in that area for a considerable amount of time. Better said, is that it take 5 shots then doesn't take any more shots for a very, very, very long time.